LightingNovember 4, 2026

How to Plan Outdoor Lighting Zones and Controls

Covered patio lit at dusk

Outdoor lighting zones decide how you actually use a lighting system. Fixtures get most of the attention, but one switch for everything means the whole yard is either fully lit or dark; zones let you light the path home, the patio for dinner and the trees for the view, separately.

Here is how to plan zones, controls and capacity before any wire goes in the ground.

Start with how you use the yard after dark

List the moments you are outside in the evening or see the yard from inside: coming home, hosting on the patio, a late swim, looking out from the kitchen window. Each of those is a candidate for its own zone.

Typical zones

  • Arrival: front path, steps and entrance. Mostly safety, on every evening.
  • Facade and front trees: curb appeal, often on a schedule.
  • Patio and dining: task and ambient light, on when you are out there, usually dimmable.
  • Garden and trees: the view from inside, on in the evening.
  • Pool or water feature: separate, so it can be on or off independently.
  • Security: side yards and dark corners, possibly on motion sensors.
Step lights set into stone garden stepsUplit trees in front of a stone house at night

Arrival lighting and garden lighting usually belong on different zones.

Choosing controls

Photocell

Turns lights on at dusk. Simple and reliable, but on its own it leaves lights on all night.

Timer or astronomic timer

An astronomic timer knows sunset for your location through the year, so it can switch on at dusk and off at a set time, such as 11 pm, without seasonal adjustment.

Smart and app control

Wi-Fi or smart-home controllers let you set schedules and scenes by zone, dim lights and switch them from your phone. Some fixtures also let you adjust colour temperature.

Motion sensors

Best for security and utility areas, so lights come on only when needed.
Estate garden with path, tree and pool lighting at dusk

Separate zones let the path stay on while the garden switches off later.

Plan capacity for later

Low-voltage landscape lighting runs from transformers. Each transformer has a maximum load, and each wire run has limits before voltage drops and lights at the far end dim. A good plan sizes the transformer with spare capacity, runs wire in sensible loops or hubs, and leaves room to add a zone next year without starting again.

Keep it neighbourly

Aim fixtures at what you want lit, not into the sky or next door. Shielded fixtures, lower brightness and warmer colour temperatures reduce glare. DarkSky International recommends warm light, 3000K or lower, for outdoor fixtures.

Electrical rules in Ontario

Low-voltage fixtures run from a transformer plugged into a properly protected outdoor outlet. If you need a new outlet, circuit or any 120V wiring, that work must meet the Ontario Electrical Safety Code, needs an ESA permit, and must be done by a licensed electrical contractor when done for hire.

Common questions

How many lighting zones does a typical yard need?

Many homes have three to five: front arrival, facade and front garden, back patio, back garden, and sometimes the pool. The right number depends on how you use the space, not the size of the yard.

Can I add more lights later?

Yes, if the transformer and wiring were sized with spare capacity. That is the main reason to plan the whole system at the start, even if you install it in stages.

Are solar lights a good alternative?

Solar stake lights can mark a path, but they are usually dimmer and less consistent, especially in winter with short days. For lighting you rely on, a low-voltage system is more dependable.

Planning outdoor lighting?

We design outdoor lighting in zones with controls you can actually use. Lighting pairs well with a new deck or pergola. Book a free estimate.
Sources: DarkSky International; Electrical Safety Authority.

Latest articles

START A PROJECT

Contact CertifiedLandscaping Today

Ready to transform your outdoor space? Contact us today for a consultation.

  1. 01
    Tell us about your propertyA few lines and your postal code is enough.
  2. 02
    Free estimate appointmentWe visit, measure and talk through ideas.
  3. 03
    Design and quoteA clear plan and price before any work starts.
Hours
Mon to Fri, 8 am to 7 pm

Request your free estimate