Natural Stone Patio Care: Sealing, Cleaning and Salt
Natural stone patio care starts with knowing your stone. Natural stone ages well when it is looked after and badly when it isn't, and the care that suits granite can damage limestone.
Here is how to keep a stone patio, walkway or set of steps looking good for decades.
Know your stone
Limestone, granite, flagstone and slate.
•Limestone: calcium-based, so it reacts to acids. Avoid vinegar and acidic cleaners.
•Granite: dense and hard-wearing; resists most stains and chemicals.
•Sandstone and many flagstones: porous; absorb water and stains more readily.
•Slate: layered; quality varies, and lower grades can flake in freeze-thaw.
Routine cleaning
For most stone, regular sweeping and a rinse with water does most of the work. For a deeper clean, use a pH-neutral cleaner made for natural stone and a soft brush. Avoid bleach, vinegar, and acidic or alkaline cleaners unless the product is made for your stone type. Pressure washing on a low setting can be fine on dense stone, but high pressure can etch soft stone and blast out joints.
Most stone only needs sweeping, rinsing and a pH-neutral cleaner.
Stains
✓Food, wine and grease: blot quickly; clean with a stone cleaner. Oil stains may need a poultice.
✓Leaves and tannins: usually fade with sun and rain.
✓Rust: use a rust remover specifically labelled safe for your stone.
✓Efflorescence (white haze): often fades on its own; dry-brush it off rather than washing.
Should you seal natural stone?
Sealing is about reducing absorption. A good penetrating (impregnating) sealer soaks into the stone and makes it repel water and oil without changing the surface much, while still letting moisture vapour out. It is most useful on porous stones like limestone and sandstone, especially in dining areas and around pools.
Avoid film-forming sealers that coat the surface on exterior stone: they can trap moisture, turn cloudy and become slippery when wet. Test any sealer on a spare piece or hidden spot first, and expect to reapply every few years.
Winter: the salt question
De-icing salts are one of the biggest threats to natural stone. Salt solution soaks into the pores; as it dries and recrystallizes, and as absorbed water freezes, it can cause the surface to flake (spall). Limestone and porous stones are most at risk.
✓Shovel early, before snow is packed into ice.
✓Use the minimum de-icer that works, and check it is labelled safe for natural stone.
✓Use sand or grit for traction where possible.
✓Sweep up residue once the ice is gone, and rinse the stone in spring.
✓For steps and entrances, consider heated systems that remove the need for salt.
Stone steps take the most salt; protect them first.
Joints and settling
Whether your stone is set in mortar or on a granular base, keep an eye on joints. Mortar joints should be repointed when they crack, before water gets underneath. Dry-laid stone with sand or polymeric joints should be topped up when they wash out.
Common questions
How often should natural stone be sealed?
It depends on the stone, the sealer and how much use the area gets. A simple test: sprinkle water on the surface. If it darkens quickly instead of beading, it may be time to reapply.
Does sealing make stone slippery?
Penetrating sealers generally don't change surface grip much. Film-forming coatings can make stone slick when wet, which is one reason they aren't recommended for exterior paving.
Can damaged stone be repaired?
Individual damaged pieces can often be replaced. Lightly worn surfaces can sometimes be honed or cleaned. Ask for spare stone from the original installation to keep for future repairs.