Interlocking Paver Maintenance: A Year-Round Guide
Interlocking paver maintenance takes about a weekend a year. Interlocking pavers are built to last decades, but how they look after five or ten years depends a lot on that simple care.
Here is a season-by-season routine, plus what to do when something goes wrong.
Spring: clean up after winter
✓Sweep off sand, salt residue and debris left by winter.
✓Rinse with a garden hose and a stiff broom. Avoid high-pressure washing close to the joints, which blasts out joint sand.
✓Check for low spots, lifted edges and loose pavers caused by frost.
✓Pull any weeds that have rooted in the joints, and top up joint sand where it has washed out.
A spring sweep and rinse keeps joints and surfaces clean.
Joint sand: the key to everything
The sand between pavers is what makes them interlock. When joints are full, pavers lock together and spread loads; when joints empty, pavers can shift and weeds and ants move in.
Many installations use polymeric sand, which contains binders that set after wetting and resist washout and weeds. It has to be installed correctly: swept into dry joints, compacted in, excess blown off the surface, then misted, not flooded. Leftover polymeric sand on the paver faces can leave a haze.
Full, firm joints keep pavers locked and weeds out.
Summer: stains and weeds
•Oil and grease: blot fresh spills, then use a cleaner made for concrete pavers.
•Rust from furniture or fertilizer: use a rust remover designed for pavers; test in a hidden spot first.
•Organic stains from leaves and berries: usually fade with sun and rain, or clean with a paver cleaner.
•Weeds: pull them early, then refill the joint. Weeds are a symptom of joints that have lost sand.
To seal or not to seal?
Sealing isn't required, but it can deepen colour, make stains easier to clean and help lock joint sand. Choose a sealer made for concrete pavers, follow the manufacturer's timing (new pavers often need to cure first), and expect to reapply every few years. A poorly applied sealer can trap moisture and look cloudy, so this is a job worth doing carefully.
Fall: prepare for freeze-thaw
✓Clear leaves so they don't stain or hold moisture against the surface.
✓Make sure downspouts and slopes send water off the pavers, not onto them.
✓Top up joints before winter so water can't get into the base.
Winter: shovels and de-icers
Pavers handle snow well. Use plastic shovels or a snow blower with skids set slightly above the surface. Ask your snow contractor to raise the plow blade or use a rubber edge. For ice, check your paver manufacturer's guidance on de-icers: rock salt is widely used but can be hard on concrete and nearby plants, so use the minimum that works and sweep up the excess once the ice is gone.
Plastic shovels and raised plow blades protect the surface.
When to relay a section
If a few pavers have sunk or lifted, they can be removed, the base corrected and the same pavers reinstalled with fresh joint sand. This is one of the biggest advantages of interlock over poured concrete. If dips appear across a large area, the base itself may need rebuilding.
Common questions
How often should joint sand be topped up?
Check joints each spring and after heavy pressure washing. Polymeric sand that was installed well can last several years; regular sand may need topping up more often.
What causes white haze on pavers?
Usually efflorescence, natural salts carried to the surface by moisture. It often fades by itself over a season or two. Paver cleaners made for efflorescence can remove it once it stops appearing.
Can ants damage pavers?
Ants nest in sandy joints and can carry sand out, loosening pavers over time. Keeping joints full and firm, especially with polymeric sand, discourages them.